Tribomar2022
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Tribomar2022
-
-
Thank you for the answer!
On 1/12/2022 at 8:30 AM, ahoeben said:Please upload them somewhere
I added them to the post as .gcode, but I can't really see a big difference.
-
when starting a print with the UM2+ from cold the machine doesn't start the print process but restarts the whole system. the bug occurs only with new gcodes; an old gcode, from about 4 weeks ago, works with no problem.
When I start with the old gcode, abort after a few minutes heating and start the new gcode it works fine, so this is a workaround.
I just updated the firmware thethe bug persists.
does anyone have a solution to this bug?
all the best 🙂
Ultimaker 2+ turns off right after strting the pre heat/print
in UltiMaker 3D printers
Posted · Edited by Tribomar2022
ok, I checked it, Cura-gcode works no problem...
I didn't do anything with the code. so far I did all the drawing and slicing with Fusion360 and didn't have any issues. I will try to find where is cane from and change it.
However, thanks for the helping to find the bug, the explanation is simple and plausible. Great work!