[Can't change G-code Flavor since 5.3.0]

6 hours ago, Piov666 said:

Same issue here too ^^

It's so frustrating :D

Very much so!

I haven't found anything that could help unfortunately  :/

[Can't change G-code Flavor since 5.3.0]

Alright, then I'm not alone at least! Then it is a new "feature" of 5.3.0

 

I hope devs are looking into this, I've tried going through all files that felt relevant in AppData folders to see if I could change the flavor for the machines there but I didn't find such a solution.

 

[Can't change G-code Flavor since 5.3.0]

Previously I've been jumping back and forth between Marlin and RepRap flavor. ( I'm running Klipper )

Mostly I just use Marlin, but whenever I need to postprocess a gcode, (continue a failed print for example ) I switch to RepRap because it uses relative extrusions.

 

It is set to RepRap now and when I try to change it, it just goes back again.

Can't slice a file with another flavor anymore, tried saving, restarting etc. Only chance might be to create a new machine perhaps. But I'd like to find a better solution for this if possible

 

Ideas?

[Bridging doesn't work for me in 4.12]

As far as I can tell I use the same settings and bridging works for me on the older cura master but not in 4.12

Could someone take a look and let me know if something's up?

3mf attached

 

Thanks

MagnetLada_BridgeFail.3mf