UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So here's where I am sitting. I have this model that I ran 'make overhangs printable' on and I like what it did to change the model. But it still needs support. I have not found a way to have it change the model And place supports. So I was thinking if I could get it to give me the model With the changes baked in then I could reslice it with supports on. Any one know if this is possible? I will attach the model if any one wants to play around with it.
Need help with 'make overhangs printable'
in Improve your 3D prints
Posted
So here's where I am sitting. I have this model that I ran 'make overhangs printable' on and I like what it did to change the model. But it still needs support. I have not found a way to have it change the model And place supports. So I was thinking if I could get it to give me the model With the changes baked in then I could reslice it with supports on. Any one know if this is possible? I will attach the model if any one wants to play around with it.
Thank you for your time
Aggro
halloween-bottom-flat-base.stl