UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So, I went and tried all the recommended values which are 0.12, 0.16, 0.2 and 0.28 mm and it might help a bit with the higher quality ones but the top layers always seem to be missing, so I went and tried the limits which are 0.04 and 0.32 mm and I still get the issue.
I'm not sure if it's the curvature of the model because even if the model has the same curvature in a lower layer it works, the issue only seems to affect the top layers.
Is this normal? Top layers
in UltiMaker Cura
Posted
So, I went and tried all the recommended values which are 0.12, 0.16, 0.2 and 0.28 mm and it might help a bit with the higher quality ones but the top layers always seem to be missing, so I went and tried the limits which are 0.04 and 0.32 mm and I still get the issue.
I'm not sure if it's the curvature of the model because even if the model has the same curvature in a lower layer it works, the issue only seems to affect the top layers.