UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We purchased some new material (Luvocom® 3F PAHT KK 50056 BK FR Filament) which prints at around 250-270 degrees.
I finished my first print but there’s an issue when the printer goes through its finishing procedure. When it goes to clear out excess material it’s already cooled down below 200, which means it can’t retract the material and gets stuck in the nozzle and I have to go through the wizard and remove it.
I can’t see any options in the settings to change this, does anyone know what I can do? This would mean every time we use this material I’ll have to clear it out after to remove it. I’ve just completed a 2nd print and had the same issue again.
Material Stuck when print finished
in UltiMaker 3D printers
Posted
We purchased some new material (Luvocom® 3F PAHT KK 50056 BK FR Filament) which prints at around 250-270 degrees.
I finished my first print but there’s an issue when the printer goes through its finishing procedure. When it goes to clear out excess material it’s already cooled down below 200, which means it can’t retract the material and gets stuck in the nozzle and I have to go through the wizard and remove it.
I can’t see any options in the settings to change this, does anyone know what I can do? This would mean every time we use this material I’ll have to clear it out after to remove it. I’ve just completed a 2nd print and had the same issue again.
Thanks.