UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I can't find the checkbox to control retraction settings in the Material menu section of print settings in Cura 4.13.1. I think it should be immediately following Build Plate Temp, but I show flow settings.
I am running a Mingda Magician X printer and needed to create a custom printer because it is not supported out of the box yet by Cura.
Perhaps there is a printer attribute I am not setting correctly and Cura doesn't know it is a direct feed printer?
Can't see retraction enable checkbox in Material Menu Cura 4.13.1
in UltiMaker Cura
Posted
I can't find the checkbox to control retraction settings in the Material menu section of print settings in Cura 4.13.1. I think it should be immediately following Build Plate Temp, but I show flow settings.
I am running a Mingda Magician X printer and needed to create a custom printer because it is not supported out of the box yet by Cura.
Perhaps there is a printer attribute I am not setting correctly and Cura doesn't know it is a direct feed printer?
Any suggestions of how to get this working?
Thanks.
Jake