UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm very impressed with v5 so far. I just run a wall thickness test from 0.2mm to 1.1mm in 0.1mm increments. All sliced correctly and printed very precisely. with a 0.4mm nozzle size the thin walls below 0.4mm measured about 0.35mm, but were clean, strong and consistent, impressed that they even printed to be honest. Above 0.4mm each wall was +0.02 to +0.04mm from there nominal values. Slight profile tweak and think she will be spot on 🙂.
Ultimaker Cura 5.0 beta
in UltiMaker Cura
Posted
I'm very impressed with v5 so far. I just run a wall thickness test from 0.2mm to 1.1mm in 0.1mm increments. All sliced correctly and printed very precisely. with a 0.4mm nozzle size the thin walls below 0.4mm measured about 0.35mm, but were clean, strong and consistent, impressed that they even printed to be honest. Above 0.4mm each wall was +0.02 to +0.04mm from there nominal values. Slight profile tweak and think she will be spot on 🙂.