UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Printing a few parts with AA0.8 and some of the walls are messy. Have printed a few prototypes and everyone got the same problem on the side. Using the extra fast profile for the 0.3mm layer.
I think it is the travel move that makes the problem with a nozzle that's leaking. Combing is set to not in the outer surface but when I inspect the Gcode I can see travel in the outer surface. Is cura so dumb that it thinks that I am still using a nozzle that's is 0.4 and it's ok to travel so close?
Problem with printcore AA 0.8-Posible bug in Cura
in Improve your 3D prints
Posted
Hi!
Printing a few parts with AA0.8 and some of the walls are messy. Have printed a few prototypes and everyone got the same problem on the side. Using the extra fast profile for the 0.3mm layer.
I think it is the travel move that makes the problem with a nozzle that's leaking. Combing is set to not in the outer surface but when I inspect the Gcode I can see travel in the outer surface. Is cura so dumb that it thinks that I am still using a nozzle that's is 0.4 and it's ok to travel so close?