UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I searched for quite some time and couldn't find anything similar to my issue that has been addressed recently. I have been 3d printing off and on for a few years now. I have always used cura as my software. I either download files from places like thingiverse or use Fusion 360 to create my own. Never had a problem.
Today I opened up Cura 4.1xx and saw the pop up that 5.0 update was out. I went ahead with my print and had no issue. Less than an hour later I went to print the exact same thing but decided to update to 5.0. Now I get a pop up issue saying that " Print setup disabled. G-code file can not be modified."
I am using an Ender 5. Cura 5.0 has already populated all my settings from Cura 4.1 and had my printer setting saved. I have gone through several of my saved gcode files from 4.1 and none of them will open on 5.0.
Has anyone else ran into this issue? Can't seem to find a fix for it.
Updated to 5.0, files wont load
in UltiMaker Cura
Posted · Edited by AudiQU4TTRO
Hello there,
I searched for quite some time and couldn't find anything similar to my issue that has been addressed recently. I have been 3d printing off and on for a few years now. I have always used cura as my software. I either download files from places like thingiverse or use Fusion 360 to create my own. Never had a problem.
Today I opened up Cura 4.1xx and saw the pop up that 5.0 update was out. I went ahead with my print and had no issue. Less than an hour later I went to print the exact same thing but decided to update to 5.0. Now I get a pop up issue saying that " Print setup disabled. G-code file can not be modified."
I am using an Ender 5. Cura 5.0 has already populated all my settings from Cura 4.1 and had my printer setting saved. I have gone through several of my saved gcode files from 4.1 and none of them will open on 5.0.
Has anyone else ran into this issue? Can't seem to find a fix for it.
-Thanks
Edit: Spelling