UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I'm having problems with under-extrusion of the fill in my ultimaker 2. I've been following some recommendations found on the internet to physically fix this problem (feeder pressure, clean nozzle, etc) without any luck.
The first layer is ok, but from the second layer the printer starts to under-extrude. I took a look in cura to see if there was something about the flow and I noted that the printed piece correspond with the flow view in cura (1st layer ok, 2nd layer less flow), but not with the flow values (see attached image).
Under-extrusion fill, ultimaker 2
in Improve your 3D prints
Posted
Hi everyone,
I'm having problems with under-extrusion of the fill in my ultimaker 2. I've been following some recommendations found on the internet to physically fix this problem (feeder pressure, clean nozzle, etc) without any luck.
The first layer is ok, but from the second layer the printer starts to under-extrude. I took a look in cura to see if there was something about the flow and I noted that the printed piece correspond with the flow view in cura (1st layer ok, 2nd layer less flow), but not with the flow values (see attached image).
Do someone knows how to fix this?
Thanks in advance!