UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
My S3 had been working flawlessly for months, now leveling fails after probing the right hand side of the plate only (fails on the 7th touch).
I've checked all the known issues, updated firmware, manual leveled, chacked plate height etc Sensor diagnostics on latest firmware results in a figure
of 1.6, in the stable release it indicated sensor is ok. I'm an electronics tech, I've checked relevant connections and there's no obvious board damage.
I've also tried leveling with the fan disconnected.
I dont have a reseller near me so its a real pain. Is it worth just replacing the sensor ??
Leveling Problems
in UltiMaker 3D printers
Posted
Hi
My S3 had been working flawlessly for months, now leveling fails after probing the right hand side of the plate only (fails on the 7th touch).
I've checked all the known issues, updated firmware, manual leveled, chacked plate height etc Sensor diagnostics on latest firmware results in a figure
of 1.6, in the stable release it indicated sensor is ok. I'm an electronics tech, I've checked relevant connections and there's no obvious board damage.
I've also tried leveling with the fan disconnected.
I dont have a reseller near me so its a real pain. Is it worth just replacing the sensor ??
regards