UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I too had issues getting the 'appimage' version of Cura 5 to run on Ubuntu 22.04.
On looking around I found that just installing the older fuse 2 library, (not the complete fuse package with utilities, etc), fixed this problem for me:
sudo apt install libfuse2
Don't try to install the whole of 'FUSE 2' - its not fully backwards compatible with the later version (FUSE3) used in Ubuntu 22.04 - I found this out the hard way 😖, by trying that first...
Typing:
./Ultimaker-Cura-5.0.0-linux.AppImage
In the directory where the 'AppImage' is located should then run the application, (I get a few QT warnings, but that's another story).
Cura 5.0.0 appImage not executing in Linux 22.04
in UltiMaker Cura
Posted
Hi,
This is my first post, so hello everyone!
I too had issues getting the 'appimage' version of Cura 5 to run on Ubuntu 22.04.
On looking around I found that just installing the older fuse 2 library, (not the complete fuse package with utilities, etc), fixed this problem for me:
sudo apt install libfuse2
Don't try to install the whole of 'FUSE 2' - its not fully backwards compatible with the later version (FUSE3) used in Ubuntu 22.04 - I found this out the hard way 😖, by trying that first...
Typing:
./Ultimaker-Cura-5.0.0-linux.AppImage
In the directory where the 'AppImage' is located should then run the application, (I get a few QT warnings, but that's another story).