UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Thanks, IrobertI, I did lower the layer thickness and that did help a lot. It's not perfect but much better than it was. This part will be a little heavier but it's a small part so it won't make a lot of difference.
geert2, RC plains need to be light weight. They generally will hold together on steep turns and rough landings, but if you crash it will break like most other materials. The glue seams are the weak link.
When printing single wall wing tips for rc planes I get this wide spacing between layers as it goes around the curve of the wing tip. Is there a fix for this in the Cura settings?
problem with printing single wall rc wing tips
in Improve your 3D prints
Posted
Thanks, IrobertI, I did lower the layer thickness and that did help a lot. It's not perfect but much better than it was. This part will be a little heavier but it's a small part so it won't make a lot of difference.
geert2, RC plains need to be light weight. They generally will hold together on steep turns and rough landings, but if you crash it will break like most other materials. The glue seams are the weak link.