[How do I add space between a raft and supports?]

That is unfortunate. For some prints it makes post processing much more difficult than it needs to be. For example, if I wanted to print a bowl, with the model facing down to get better surface finish on the bottom of the bowl, it would be a pain to remove anything because the supports are all bonded to the raft. Whereas, if I could add a gap underneath the supports and take the raft off first then the supports would be easy to pluck away. 

 

Is there anyway to request this feature be added? 

 

Thanks

[How do I add space between a raft and supports?]

Hello, I cannot figure how to add space between a raft and supports coming from it. The "Raft Air Gap" sets the distance between the top of the raft and bottom of the model, but apparently this does not apply to the supports. This causes a headache where the supports are bonded with the raft and a pain to remove. Is there a way to fix this? 

 

Cura Version 5.2.1

MotorMount^Production Fixture.3mf

[Why do these walls have non-uniform slicing thickness that occurs in-line with cutout features?]

I am trying to print a simple coupler piece, however, when I slice it the inner hole diameter is not consistent. The incongruity occurs level with the side hole for the thread insert. I have the same problem with a bracket piece that has a side cutout for a rocker switch. Any ideas? I have been searching for a while and can't find anything on this. Thanks

 

.

Bottom Cover^3800 MR Relay Fixture.STL Coupler.3mf Coupler_short^3800 MR Relay Fixture.STL