UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hello, I have issue with printing of ASA fillament. I'm using Fillamentum ASA Traffic Black in Ultimaker S5 with AA0.8 printing core. For few months printing quality was fine, afther a while I started noticing "blobs" on outer walls. It is usually worse on shorter or curved surfaces. Simillar issue is with AA0.4 but in smaller scale.
During printing I can hear "pops" which leaded me to wet fillament (this is happening even with brand new spools) but even after drying (80°C for 5 hours) there was no progress.
I also tried to clear and change for new core without any results.
Ultimaker S5 - ASA quality issues "blobs"
in Improve your 3D prints
Posted
Hello, I have issue with printing of ASA fillament. I'm using Fillamentum ASA Traffic Black in Ultimaker S5 with AA0.8 printing core. For few months printing quality was fine, afther a while I started noticing "blobs" on outer walls. It is usually worse on shorter or curved surfaces. Simillar issue is with AA0.4 but in smaller scale.
During printing I can hear "pops" which leaded me to wet fillament (this is happening even with brand new spools) but even after drying (80°C for 5 hours) there was no progress.
I also tried to clear and change for new core without any results.
Does anyone know what can cause this?