[gradient infill]

HI, I tried your link but it seems its been deleted. Is it possible to reshare it.

I am searching for a plugin that would specifically give me 2-3 different infill densities across the model.

Example - Imagine a circle/cylinder, 20% infill density in the middle, 60% at the end and maybe say 40% in between both those infill density. Again this is just an example.

Even if whats available is not that complex and gives me a range between two infill densities I am okay with testing that.

[After a crash i am unable to move the printer along the Zaxis]

Hello

I use a Cellink BioX Printer

I use Cura to slice my objects

It used to work just fine but after a crash i had to use backup and reset option

After that all the G codes that are generated by cura don't print on the surface

When i adjust the Z manually it prints but on the same layer instead of moving along the Zaxis

I uninstalled the software and then installed it again but it has the same issue with no movement along the Z axis

My old g codes still work properly

Gcode that my friend made also work properly

 

My Start Gcode

G90
G21

My End Gcode

G1

Z30

 

This G code was working properly prior to the software crash

Hope someone help me with this

Thank you

Printer Issue.zip