[Brims Printing Under Project Pieces?]

I can assure you the text was not extended down until I imported it into Cura. These are the screen shots from Tinkercad.

[Brims Printing Under Project Pieces?]

I get what your saying but why did Cura add that bottom layer of text? According to Tinkercad there is no layer of text on the bottom.  In fact the text should not even start until 1mm in height. I have also used the same template to create approximately 25 tags with different names and never run into this problem.

[Brims Printing Under Project Pieces?]

Im not sure why  but when I try to print these dog tags the brim prints under the flat bottom of the tags. I have the brim set to be 10mm from the project and it has a flat bottom so it should be pretty easy for Cura 5.3 to figure this out. I have never seen this happen before. Any ideas how to fix it?

CE3E3V2_Dogtags(1).3mf

[Objects Shrinking in Vase Mode]

Hello, I am trying to print a traffic wand for some flashlights using vase mode in Cura. When ever I try to print it  using vase mode the item shrinks  by approximately  9% . Taking the wall thickness into account the item should print  with an outside diameter of  41.8mm but in Vase mode in comes out at 38.2mm.  If I print the object in normal mode it prints at the correct dimension of 41.8mm.  The shrink factor compensations are all set at 100%. The scale factor on the model shows as 100% with the correct dimensions so I do not think I did anything to the scaling of the model either.

I am using Cura 5.3.0 and printing on an Ender 3 V2.

 

Does anyone have any ideas how to correct this? I know I could manually upsize the scaling until I get a good print but I would prefer to find out what is causing the problem.