![](http://content.invisioncic.com/ultimake/set_resources_16/84c1e40ea0e759e3f1505eb1788ddf3c_pattern.png)
NaGaNn
-
Posts
10 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by NaGaNn
-
-
-
-
-
-
Thanks very much for your time, I appreciate it !
-
Hi !
1) I have never tried with a 0.8 mm nozzle before installing the olsson block. I tried with the same speed and material but with a 0.5 layer height.
2) The temperature dips by 5C
3) The printing speed is 60mm/s. I used ABS (TitanX from FuturaForm) with a 0.6 mm layer height.
Thank you !
-
Yeah that's the sensor that I changed, sorry. I tried with 0.6 and 0.4 nozzles and i didn't have the heater error. And no, the heater block isn't touching the fan shroud.
-
22 minutes ago, gr5 said:
If it's ER03 then you might want to buy a heater with a higher wattage rating. Why did you buy a new heater? Where did you get the heater?
Yes it's ER03. I bought a new heater because the old one broke inside the previous heater block. I bought this heater :https://ie.rs-online.com/web/p/3d-printer-parts/9082957
-
Hi guys !
I recently installed an Oldson block and a new heater on my Ultimaker 2 and I printed the benchmark boat with a 0.25 nozzle and had no problem. I changed the nozzle for a 0.8 to print a bigger project, and the heating problem appeared. My nozzle temperature is getting lower and lower while printing, but the fans are off. Then an heating error appears on the printer. Have you ever had this problem ?
Problem at the end of every print
in UltiMaker 3D printers
Posted · Edited by NaGaNn
Hi, thank you for your answer, here are more informations :
- I'm using an Ultimaker 2
- I did perform routine maintenance recently
- I'm printing with ABS
- My version of Cura is 5.3.1
- I can share a file if you want but this issue is with everything I try to print
Thank you for your time, i'm not used to forums so I appologize for the lack of information
UM2_Coupler Cover Plate 73_8mm x 43_3mm v1.3mf