UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I've been printing pretty successfully for a while on my Ender 3 with SKR Mini board. Using CURA as my slicer, I typically have good results. My last several prints have had significant issues. I use a BL Touch for leveling. Not sure what's contributing to this. Replaced nozzle, no change...
Any tips/suggestions on how to remedy?
EDIT: Turned on monotonic (for the heck of it), and while it started from the lower right corner this time, you can see that the areas where the issue is manifesting is different..
New Extrusion / Adhesion Issue
in Improve your 3D prints
Posted · Edited by AverageJoeRacer
I've been printing pretty successfully for a while on my Ender 3 with SKR Mini board. Using CURA as my slicer, I typically have good results. My last several prints have had significant issues. I use a BL Touch for leveling. Not sure what's contributing to this. Replaced nozzle, no change...
Any tips/suggestions on how to remedy?
EDIT: Turned on monotonic (for the heck of it), and while it started from the lower right corner this time, you can see that the areas where the issue is manifesting is different..