Ry-7hym
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Ry-7hym
-
-
For me it was the sensor and shield wires not connected properly. I removed them earlier because I had to re-solder them due to a failure before. I switched them around and now the printer works fine again. (This was on an Ultimaker 3 by the way)
Active levelling could not be performed
in Improve your 3D prints
Posted
Oh sorry no that was not what I meant. I only re-soldered the wires to the connector pins. I soldered them to the correct points but I switched the two connectors. So I connected one of the fans to the sensor and shield plug.
So I didn't have to re-re-solder them ^v^"