lesliechw
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by lesliechw
-
-
Hello all,
I have this problem with Cura 5.5 and 5.6. I set the wall to be 1 line but it keep generate 2 line. Happen on Cura 5.5 and 5.6.
Earlier version of Cura have no such problem. May I know are there any new setting that cause this? How can I make it to 1 line again? Please advice, thanks a million.
Wall set 1 layer but it keep slice into two layer wall
in UltiMaker Cura
Posted
Thanks for your reply. Actually I do tried setting the wall line to 1 too. The result is the same. This same setting in Cura 5.4 don't have this issue.