[How to prevent "overshoot" corners or "round edges"]

On 2/10/2020 at 7:05 PM, Creat0r said:

Hey there,

I had this problem too, in case of an Ultimaker there are two ways to solve it:

1 Disable"Accelerations control".

2 Enable "Accelerations control" and set the print acceleration to something like 6000 or higher (You may want to leave the acceleration for tasks with higher feed rates like travel or infill just low as it was - to preserve your bearings and other printer parts).

 

So basically having a faster acceleration at the corners should do the job.

Let me know if it was helpful. :)

Hi, I was thinking about this too to just disable acceleration or set it up to huge numbers. The thing is, I need acceleration especially on outer walls, because I get a lot of ringing\ghosting. without it. So thats kind of a problem. I usually print at 70mm/s for outer and 120mm/s for inner walls and infill. Acceleration is around 150 and 250 at max, higher values again shows too much ringing. But im thinking about trying some jerk control towers with different settings if it would help somehow. I have Artilerry Sidewinder X2