Jump to content

3D printed Kratos 1.0

   (0 reviews)

1 Screenshot

About This File

This model was tested in Cura 15.06. To avoid printing problems, we recommend the following settings:

Quality

Layer height: 0.1mm*

Initial layer thickness: 0.3mm

Bottom/top pattern: lines

Skin perimeter line count: 0

Horizontal expansion: 0.04mm

Speed setups for figure:

Infill speed: 50mm/s

Outer shell speed : 30mm/s

Inner shell speed: 20mm/s

Top/bottom speed: 20mm/s

Support speed: 50mm/s

Travel speed: 150mm/s

Skirt speed: 30mm/s

Amount of slower layers: 4

Speed setups for axes: It is recommended to print the axes at 0.1mm layer height.

Infill speed: 50mm/s

Outer shell speed: 20mm/s

Inner shell speed: 20mm/s

Top/Bottom speed: 20mm/s

Support speed: 30mm/s

Travel speed: 150mm/s

Skirt speed: 20mm/s

Amount of slower layers: 4

Infill:

Infill pattern: Grid

Line distance: 3mm

Infill overlap: 20%

Infill layers: 0

Support:

Enable support: Check

Placement: Everywhere

Overhang angle: 30°

X/Y distance: 0.7mm

Top distance: 0.2mm

Bottom distance: 0.2mm

Stair step height: 0.5mm

Join distance: 0.7mm

Area smoothing: 0.6mm

Use towers: check

Pattern: Lines

Line distance: 1.5mm

Platform adhesion:

Type: Brim

Brim line count: 10 (up to 20, depending on the model’s height)


User Feedback

Create an account or sign in to leave a review

You need to be a member in order to leave a review

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

There are no reviews to display.

×
×
  • Create New...