[Heated Bed not working with Ulticontroller enabled]

I can explain this for dummies

"I have the same issue earlier and I resort to download from github/ultimaker/marlin to build it manually. You need to uncomment the #define BED_LIMIT_SWITCHING or #define PIDTEMPBED depending on if you are using a relay or MOSFET to control your bed. Also, don't forget to uncomment the #define ULTICONTROLLER and TEMP_SENSOR_BED to enable the temperature monitoring."

I find github/ultimaker/marlin to build it manually.

[heated bed not working]

Hello

I'm trying to install a warm bed, I have followed this show

https://docs.google.com/file/d/0By8zvmG ... p3TnM/edit

Connection to relay

https://docs.google.com/file/d/0By8zvmG ... dTT2s/edit

Connection to termistor

The NTC thermistor is tpo

https://docs.google.com/file/d/0By8zvmG ... 1pTnM/edit

4.7k resistor soldered

https://docs.google.com/file/d/0By8zvmG ... RGeDg/edit

Custom Marlin

I do not even know where to begin to review

Mounting or firmware??

[Heated Bed not working with Ulticontroller enabled]

had managed to put the extension Hand .hex

[Heated Bed not working with Ulticontroller enabled]

Just let me download linked file to save as, I put the name Marlin and I keep it, the problem is that when I open the priest tell me Expert/Install custom firmware not recognize the file

[Heated Bed not working with Ulticontroller enabled]

Hello, when I generate the new file in

http://daid.eu/~daid/marlin_build/

, give it a download and opens another page in the browser, but I do not download, how do I install the cura?

P,D I have a mac

THANKS

[Low temperature]

Hi I happen to me when printing temperature goes down, and after a while it stops printing without completing

[Plastic does not go to print]

driver Ultimaker sperimental sprinter/Marlin firmware

gcoder generator skeinforge (40)

firmware Marlin experimental build 3 by bernhard's

[Plastic does not go to print]

On the parameters of dimension says:

Activate dimension, activate

Absolute extrusion distance, activate

Relative extrusion distance, off

Extruder retraction spedd (mm/s) 0,0

Filament diameter (mm) 2,8

Filament packing densiti (ratio) 0,85

Retraction distance (milimeters) 0,0

Restart extra distance ( milimeters) 0,0

What can i do?

[Plastic does not go to print]

primero perdon por mi ingles de google traductor.

I ride my Ultimaker, everything moves along with the control panel operated by hand is extruder and goes well the PLA at 210 °, but when I send print I get little or no plastic, while the print engine of the extruder is not moves, what am I doing wrong?