![](http://content.invisioncic.com/ultimake/set_resources_16/84c1e40ea0e759e3f1505eb1788ddf3c_pattern.png)
tresdemaker
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by tresdemaker
-
-
Hello, my Ultimaker has stopped printing, the message appeared yesterday "Error:mind temp" in ulticontroller. I have moved the wires from the plate and no longer get the error, but the temperature does not rise. I have seen where it is written Heater 1 has melted solder ... I thought that if I change the cables and put in place the Heater 2 (what is perfectly welding) could be a solution. What do you think? Is it possible? would have to make changes in the firmware?
thank you in advance.
Error Mintemp. Heater 1 has melted solder in the mainboard.
in UltiMaker 3D printers
Posted
Hi! gr5, thank you for your answer. And for the fixing![;)](//content.invisioncic.com/ultimake/emoticons/5a33abe00be82_1f609copy.png)
I have good news, I finally got to fix my Ultimaker. The problem was in a weld, had little tin. I soldered one pin on the motherboard "Heater 1" and now works fine.
Thx!