codeangel
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by codeangel
-
-
Hi Folks!
With Cura 13.06 / I have a problem that support structure is slightly smaller then the object it is supposed to support, please see here:
This is how Cura 13.03 did it, support structure is either alligned with object or even wider:
http://fallout.codeangels.com/misc/cura_support/cura_13.03.png
This is Cura 13.06, support structure is smaller then the model and leaves outer wall in the air, this causes bad prints:
http://fallout.codeangels.com/misc/cura_support/cura_13.06.png
How can I address this issue?
Thanks
Kirill
Adruino self power broke down on 1.5.4 electronics
in UltiMaker 3D printers
Posted
Hi!
I have a Ultimaker with 1.5.4 electronics patched to self power the Adruino, it was working fine for several month but today the printer "died" in the middle of long job, as it came out the self power stopped working. Printer seems to be working fine if I power the Adruino via USB.
EDIT: As it came out, the 12v fan output leads on main PCB are indeed dead, no voltage on them, am I correct to assume that the most obvious source for the error would be voltage regulator on IC1 slot (L7812CV)?
Thanks!
Kirill