keesjalink
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by keesjalink
-
-
Adding to this discussion,
I had exactly the same problem and the solution was exactly the same: it seems that sometimes there was a slight problem with the side panels shipped ~may 2013. Replacing them with a new set did not help (panels had the same problem, but I only discovered that after mounting) and then a third set of panels (shipped free by UM) cured the problem and made my prints much better.
Lesson: this is not all that uncommon. Check your panels and especially make sure the X and Y axis are level. The easiest way to check: if the bed leveling does not work out (in one corner, the printed line is too thick or thin) you should suspect this problem.
After some back-and-forth emailing, solved well by UM support.
Kees
-
Hi all,
is there any progress on this issue yet?
I desperately need to control UM I from a tablet running android.
Thanks, keep up the good work, Kees
GCode Simulator & Printer - Test on Ultimaker
in UltiMaker Cura
Posted
Thanks. I had the impression no-one had tested it yet but if it should work, I'll risk a few bucks...
Trying tnight.
Kees