jhenn
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by jhenn
-
-
My Ultimaker 1 is becoming misaligned along the x-axis.
I have checked the belts by loosening the motors, pushing down and tightening and by adding belt tighteners where required. I have also tightened the pulleys (although they are quite hard to reach!).
The abnormality I can see is the small x-axis motor belts appears to be warped and twists slightly compared to the one on the y-axis. I have recorded a video of the difference here (
).I'm not sure if this is cause of my problem. If it is does anyone know of a solution?
If this is shouldn't affect my print does anyone have other suggestions of what the cause might be?
Thanks!
Printhead Misaligned Along X-Axis
in UltiMaker 3D printers
Posted
Thanks for the quick response!
I'm afraid that the results are a bit more drastic than the tilted print photo. It is more like the shifted layers photo (3rd right). See an example of a belt tightener I tried to print below.
I will try adding the spacers as suggested and report back.
Thanks!