Jump to content

row

Dormant
  • Content Count

    2
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Jonny, the initial layer thickness is 0.3mm. Cut off object bottom is set at 0.0mm. Bottom layer speed is set at 20mm/s. Should I change any of these settings? Thank you very much for the printinz link. I do think I'll get one of these.
  2. I have a new UM Original, and the prints keep getting stuck on the print bed. I've tried brim and rafts, I've tried removing the tape and replacing it each time, and I've tried putting the bed in the freezer after each print. I've also tried removing the prints with a razor blade. Does anyone have any advice? Thank you!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!