xaimill

Illuminarti: im beginning to think so. I will contact the company to see if they can send me previous firmware versions to try and re-installing in the printer. xeno: its running directly for SD card, and no, no items were being switched on or off during orinting, but its good to have that noted. Nallath: yes, I always right-click> eject SD card. Right now is either that problem from Cura, or not printing at all from a Simplify3D gcode. Very frustrating. Thanks for the replies.

I've been using Cura for slicing, been tweaking a lot because it sometimes prints in the air. Then I got this model and when I started printing it, machine suddely stops without prior notice and stays in place, creating a nest of plastic. http://i307.photobucket.com/albums/nn288/xaimill/10592185_10204441410860324_568501462_n_zps98b24193.jpg http://i307.photobucket.com/albums/nn288/xaimill/10524447_10204441410900325_1651590943_n_zps24f35d1a.jpg http://i307.photobucket.com/albums/nn288/xaimill/10582280_10204441410940326_520728093_n_zps31c0b747.jpg http://i307.photobucket.com/albums/nn288/xaimill/10595856_10204441411180332_162447476_n_zpscec0c1f1.jpg My machine is a chinese Glitar 3, it's new. Thanks in advance.

Checked the setting. It was on, so I unchecked it, saved gCode and put it to print but the machine just said "printing" and showed the % but it wasnt really doing anything. Re-checking it made printing again but still on the corner. Also, when I tell it to print, it will calibrate the XYZ axis, but then the plate will lower about an inch, and start printing in the air.

It is currently set om the "0,0" setting. I'll turn it off and see if for some strange reason that helps. Thanks, will report soon.

Hi, im new to 3D printing. I got a Glitar 3, a big build chinese 3d printer. when I save gCode from Cura and send it to the printer, it starts printing on a corner, instead of the center if plate Is there a setting I am missing in Cura? Thanks in advance