vlad-gorneanu
-
Posts
3 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by vlad-gorneanu
-
-
Hi Vlad
Welcome to the Ultimaker forum! Can you please tell us, what your other fan settings in the expert settings of Cura are?
These are my settings right now.
-
Hi all,
I have an Ultimaker 2 for a about a week now and I printer around a half of dozen things before I encountered this issue. The cooling fans do not work automatically anymore. Before, when I wanted to print something , they started working as soon as the print was starting but now I need to go to Tune(while printing) , Fan Speed and choose the % I want. If I get a higher % like 80%-85% , the fans work for a couple of minutes and they automatically go down to 5% or 7% and stay they until they don't work at all. I manually set them up again and they go down by themselves.
The only changes before a non issue status of the printer and this issue is that I tried to update the printers firmware. Nothing else.
Note that before saving the mode on the SD card in Cura, I always make sure to check that "Enable cooling fan" is ON.
Can you please help me? Have you encountered this issue?
Thanks.
Cooling fans issue on Ultimaker 2
in UltiMaker 3D printers
Posted
Blizz,
I only have 2 plug-ins but none enabled. See below.