sharkfan94
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by sharkfan94
-
-
So I almost exclusively print from an SD card so that my laptop is free. Up until a few days ago everything was working fine. But now when I start a print a slice in cura my Simple just goes to the from left corner and just proceeds to print a glob in the corner. It hasn't done this before and I can't seem to find any info about it. Does anyone have any suggests or thoughts as to what might be causing this?
Cura SD print on Printrbot simple not working..making a big glob...
in UltiMaker Cura
Posted
No, I'm saying that cura used to print perfectly without fail for me. It would home X and Y, go up 15mm then slowly move down to the middle or the bed. But then maybe a week ago it started to move Y out as far as possible, homed X then would just start the print at that location. I have tried multiple files and each ends up being a glob about 1 inch long by 1/8 of an inch wide.
I don't know how to describe it other than that it just prints a big glob in a very small area instead of starting the print like it used to.