Jump to content
Ultimaker Community of 3D Printing Experts

oscahie

Member
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. This very simple single-shell calibration piece: https://raw.githubusercontent.com/ahmetcemturan/SFACT/master/calibration/_40x10.STL Is sliced like this in Cura 14.09: Layer height is 0.2mm, shell tickness 1.2mm (but other values like 0.5 make not big difference in the visual output). The same piece is sliced correctly by Slic3r. Note: I haven't really tried printing the output gcode, I'm just assuming it won't print well at all given the visualization shown here.
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!