thebagmaster
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by thebagmaster
-
-
Greetings Everyone!
I recently purchased an Ultimaker Original+ and went through the bed leveling wizard.
I have done quite a bit of tweaking to try and get the first layer just right on some of my smaller prints.
I tried a large print and realized that the first layer varies quite a bit in the middle of the glass, odd.
Anyways, any help would be appreciated.
Thanks.
PS: PLA 195C 50C bed 100%flow 50mm/s speed 0.25mm Layer Height
I have a hard time believing that my glass is not level
in UltiMaker 3D printers
Posted
Thanks everyone, was not too worried as Cerberus pointed out after a few layers this is all but gone.
I shall try your suggestions.