Jump to content

treep78

Dormant
  • Content Count

    5
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. So I figured out where to plug in my thermistor, but I have a bit of a problem. With it unplugged my printer says it is at 500/0*c, with it plugged in it reads 480/0*c. Any idea what's going on?
  2. Thanks for all the responses! I was able to get it sorted after knowing I only needed the ground and signal. Some pics online and a multimeter got me the rest of the way (and trial and error of course). One problem solved and on the the next! Does anyone know where I hook up the thermistor? (that's the things for measuring the temp of the extruder right?)
  3. I have a 1.5.7 electronics kit that came with a set of endstops that I can't figure out how to hook up. They have 4 wires instead of the usual two I usually see with ultimakers, +, -, empty, and signal. I'm not sure which ones too hook up to the electronics board. I know that there are two prongs for each endstop, but it don't know what each of the prongs are. Can anyone help me?
  4. A while back I purchased an ultimaker electronics kit that I've slowly been building. However I have become totally stalled with the end stops. The stops that came with the kit have 4 wires. I beleive its the usual +, -, blank, signal, arangement. However I can't figure out which wires go where on the board. The endstop spots only have 2 positions and I have 3 wires I need to plug in, on top of that I don't know which one goes where. I would be really greatful if someone could help me out with this. Thanks in advance.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!