JuliusCaesar

thx for clarifying:) unfortunately I still got some strings. I tried to increase the z hop as well but that did not help. What material would you recommend which doesn't have stringing. We ordered some colorfab XT samples (red,green, woodfill and copperfill). Haven't tried those yet. @stu_le_brew: nope I'm not from Rome. I'm German, but the nick is close to my actual name

Thx for your reply, Retraction was already enabled the movement speed was at 150mm/sec. I increased that speed to 180mm/sec. I lowered the temperature from 220 to 210°C as well. Where do i change the retraction distance? Is this minimum travel in the retraction settings?

Hey guys, We bought an Ultimaker 2 couple of weeks ago and it's amazing However we encountered some problems: We use 2.85mm PLA filaments. as you can see in the picture. There are lot's of small filament parts between those two objects. We use the cura "ultimate" settings. Do you know which parameters I probably have to adjust to get rid of this unwanted connection between the 2 objects? greets Julian