UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I got some heavy stringing with one model even with lowering temperature to 190C and increasing travel speed, as shown on picture.
After reading about how to minimize it, i set Retraction minimum travel = 0, Enable combing = all,
Minimal extrusion before retracting = 0 and lowered print speed to 40mm/s.
I got sliced layers in CURA on attached image. Some of them are pretty clear , but a lot of them still have blue lines
getting over gaps , some even without retracting.
Is it possible to force avoiding holes like 100%, because on this model it is possible, and cleaning stringing after pretty impossible? Any suggestions?
Heavy Stringing with stratum vase, CURA retraction and combing question
in UltiMaker Cura
Posted
Hi,
I am new in 3d printing.
I got some heavy stringing with one model even with lowering temperature to 190C and increasing travel speed, as shown on picture.
After reading about how to minimize it, i set Retraction minimum travel = 0, Enable combing = all,
Minimal extrusion before retracting = 0 and lowered print speed to 40mm/s.
I got sliced layers in CURA on attached image. Some of them are pretty clear , but a lot of them still have blue lines
getting over gaps , some even without retracting.
Is it possible to force avoiding holes like 100%, because on this model it is possible, and cleaning stringing after pretty impossible? Any suggestions?
setup cura, i3Hephestos, colorfab PLA
Thanks