Hey All,
So when the build plate for my Ultimaker 2 starts to heat up i think there's a short somewhere, causing the printer to restart its self. Feels like its earthing out somewhere.
I've checked all the wires connected to the bed and all the solders are fine.
Only other information i can give is I've tested the bed when disconnected from the printer and got a reading of 30 ohms. Not sure if that's what its supposed to be giving off or not.
Any thoughts on this? should i just order a new heat bed? Is there anything else i could do to troubleshoot the problem?
Thanks In advance,
Josh
UPDATE: There is this small burn mark on the heat bed itself. This could be causing the problem?