Jump to content

AEON5

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    NL
  1. Thanks for the reply gr5 & the schematic! I will check for hot components later today.
  2. Hello Today my UM2 stopped printing and is totally dead. I checked this topic: https://community.ultimaker.com/topic/17152-um2-is-dead-after-short-circuit/?page=2 and checked the 24v & 5v. 24 v is ok but no 5v (or 3.3v). No lights are burning on the motherboard. Is the motherboard dead? Or is there an other solution? Thanks
  3. Is there a good white glow in the dark filament? I have only seen green en blue glowing filaments!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!