scottyshu

Thanks, that's a very helpful resource to have! Didn't know it existed! Turns out the bars were slightly not even and causing the belt to slip. Consequently it looks like they've worn down a few of the notches so I'm going to have to get a new belt to replace it with.

This has been a problem for a while now. Whenever printing anything more than a few centimeters tall, the printer shifts and starts printing in a totally different position than where it started. Usually finishes the print, just in a different area than where it started. To clarify, the misprint is where the "M" gets cut in half about halfway up. Picture of example attached.