bobbart

Hello, I am new to the 3D printer world. I purchased and built my first printer a hictop prusa i3 auto leveling printer. I think I have it all setup properly and it worked for the test print they included. I wanted to try a new print and figured I would make a cat I had seen on thingiverse.com . I downloaded the stl and opened it in Cura. I set up all the settings basic and advanced. I then tell it to print, of this was the same way I did the test print that worked. However now it wants to start the print off the back right of the print bed. I have tried a few times after doing an Auto Home and it keeps wanted to print off the back right. I downloaded and tried another stl and I get the same problem. I could really use some help understanding what I am doing wrong. I watch a few videos and they do not seem to do anything different than me. Thank you in advance for any help.