Hi,
I am new to the Ultimaker 2+ and have never worked with 3D printers before.
I am printing with black PLA using the following standard specs:
Print Height 0.1mm
Print Speed 50 mm/s
Supplied glue distributed on the glass surface before printing
Cura 15.04.4
Updated firmware on printer
3D software is Rhinoceros 3D
I am experiencing some very annoying fails on 80-90% of my prints.
See attached photos.
It seems that the printers orientation is suddently shifting 1-2mm during the print and then 10 layers up switching back to the original orientation. As you see in the attached photos it is an identical fail that happens with identical pieces even though they were not printed at the same time.
Similar issues are evident in other larger geometries as well.
If anyone has an idea to what could be the issue it would be highly appreciated.