poinko
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by poinko
-
-
-
help please, the problem persist, and icant print large
-
Buy a UM2 +, it took a week to 30 hours without problems printed.
But now after updating the latest firmware, I have problems printing in the right corner of the print.
After 4 unsuccessful attempts, all there, try Bed leveling, glue, Bed leveling again, clean the base, nothing works, follows the same error.
Please help
HEEELP print problem in the right corner
in UltiMaker 3D printers
Posted
And the same problem width the first layer 0.2 height.
The bed is on a level surface.
The problem is only in the back right. How do you can only calibrate the rear right side ?, because in the front right there is no problem.
Look if there was something on the back that would push up, but there is nothing
Help please,
Ultimaker moderator, you're my only hope