Jump to content

krioux

Dormant
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

1 Neutral

Personal Information

  • Country
    CA
  1. Yes it's PLA. This should help, I'll try it next time I change material. Thanks!
  2. krioux

    NinjaFlex

    Thanks, that's very helpful!
  3. krioux

    NinjaFlex

    I'm new to 3D printing but I'd like to add some NinjaFlex to my inventory. I have the Ultimaker 2+ which says it takes 2.85 mm diameter filament but the NinjaFlex only comes in 1.75 and 3 mm. I'm assuming the 3 mm is the one I would need but just wanted to check with some more experienced people before I purchase.
  4. When I change materials in my Ultimaker 2+ the feeder breaks the material off when trying to pull it back. This leaves the feeder tube full of material which causes more problems when trying to load a new material. Is this a common problem? Any suggestions to keep the material from breaking?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!