[UM2 controller reset/reboot when opening USB port on Linux]

Hi @Daid and @Steve,

I encountered a similar issue while trying to connect my Ultimaker 2 Extended + to a raspberry pi. I was trying to get data from temperature sensors while the print was in progress. But every time I sent in a request via serial from the raspberry pi , the printer would reset. After reading your post, I have some perspective on why that was happening.

However, my intention here is not to print via USB but rather just use it for getting temperature values. One crude way that I figured out was to establish the serial connection first and then start the print using the dial and display of the printer. But it seems that doing this might be interfering with the printer functions as the display intermittently shows "Printing using USB".

Is there  a way I can work around this ? And how frequently can I request such data from the printer ? Are there any serial buffer considerations?

[Cura for linux]

For the UM2 family of printers (UM2Extended+ included) it is highly recommended that you print via SD-Card. If you really want to print via USB, please try version 15.04 for now.

I am trying to update the firmware of the printer using an Ubuntu system. It just would not allow me to that. I am in fact using SD card for printing.

[Cura for linux]

What printer are you trying to use, and what version(s) of Cura did you try?

 

I have an Ultimaker 2 Extended+. I have tried Ubuntu 14.04, 15.04 and 16.04 along with different Cura versions but none have worked. As mentioned in the post below, I am not sure how to run Cura as root . What I did was to download Cura and run the software installation from the downloaded file. Do I have to run it from the terminal using sudo?

Does anything else needs to be done as well?

[Cura for linux]

Hi,

Can someone suggest a combination of Cura and Ubuntu that works?

I have tried a lot with different versions of the two but without any success. Cura simply fails to recognize the printer while I can see the device name under lsusb issued from the terminal.

[Extruder position and temperature values]

I would say I am not great at programming but I can work on any leads you provide

[Extruder position and temperature values]

Thanks a lot for replying. Appreciate it.

My intention is to record the temperature profile while printing. I know about OctoPrint which shows temperature profiles in a web browser. But I want to record that data as well. So, I was looking into how I can "talk" to the printer. What do you recommend for that ? I mean what is good way to talk to the printer through serial ? a terminal program ?

[Extruder position and temperature values]

Can anyone please explain briefly how to capture above values using serial connection to the usb?

[Where can I learn about Ultimaker Firmware and control software ?]

Hi,

Can someone please point me to a good source of information for understanding the common firmware used in 3D printers especially in Ultimaker. I wan to know it from the point of view of how Gcode is run and the actions of various motors and heating elements controlled.

Thanks a lot.

[Reading temperature values from Ultimaker 2 Extended+]

Hi,

How can I read raw temperature values from the printer over a USB connection to my computer?

[Sensors in Ultimaker 2+]

You can read the raw values with a serial connection over the usb.

 

Hi,

Would I need any special software to read those values?

Thanks

Gurtaj

[Sensors in Ultimaker 2+]

Thanks a lot for the info, Didier. That was pretty much what I was asking about. Would you also happen to know if we can record these sensor readings by some method or if they can be accessed in software like MATLAB? Does the machine make any corrective actions if it notices that there is a drift in the values from the intended values?

Thanks again.

[Sensors in Ultimaker 2+]

Hi,

I was wondering whether the Ultimaker 2+ has any sensors that keep track of process parameters like temperature of the extruder or of the build envelope etc.?

Thanks

Gurtaj