Jump to content

Trybrow

Dormant
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    GB
  1. Followed the instructions for the atomic method, but time and time again, the cone is there at the end, but an inch or so after that the filament looks like it has been bubbling and warping. I have been printing just fine since the first time I did this, and tried it again today, thought I should request some counsel. Is this normal or are there some steps I should take?
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!