Thank you, I am running a different print at the moment so it will be a while before I can try your suggestion. I did rotate my model 180 degrees on the build plate and the pattern stayed at the same physical location of the build plate even though the side hole location had changed. It is similar to a shallow V laying on its side. It appears the entire layer is offset. the pattern extrudes on the side, then indents at the first edge of the inside hole, extrudes at the far side of the inside hole and indents on the opposite side of the part. I also printed at a different location on the build plate and the pattern appeared similar. Most everything else I have printed so far is only 1/4 inch high so I don't know if this happens on different models.