Storbis
-
Posts
6 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Storbis
-
-
Hallo Gerd,
Bei meinem ersten Board waren diese vorhanden. Jedoch musste ich das Board einsenden, da die Lüftersteuerung nicht funktioniert hat.
Neu habe ich ein Board erhalten, jedoch ohne diese 2 Stecker.
Jetzt funktioniert zwar der Lüfter aber ich kann nicht mehr heizen.
Beim Vorheizen für PLA fängt nach ca. 30s das Display zu flimmern an un es steht "heating failed".
Es heizt nichts auf, Temperatur beibt bei Raumtemperatur.
Gruss Storbis
-
Hello
The heater always read about 22-26C.
When I try to heut up for PLA the temparature does not gow up. after 20-30s the display begin to flicker and on the display it prints "heating failed".
Its the same problem when I just try to heat up the heating Plate or just the nozzle.
I have installed the newest firmware.
-
I have the same problem.
do you have an answer?
-
Hello
I have the same problem like you.
Do you have an answer?
-
Hallo zusammen
Ich habe mir einen ultimaker original plus zusammengebaut. Der Lüfter hat nie funktioniert (ich konnte jedoch drucken), darum habe ich das Board eingeschickt und ein neues erhlaten.
Nun habe ich das neue Board eingebaut.
Dabei ist mir aufgefallen, dass die beiden schwarzen Plastikstecker (savety1 und savety2) nicht mehr mitgesendet wurden.
Wenn ich jetzt den Drucker für PLA vorheizen möchte passiert nichts, nach einiger Zeit fängt das Dysplay an zu flackern und es steht heating failed.
Kann mir jemand weiterhelfen?
Gruss Storbis
Ultimaker Original Heating Failed Error On First Use During Cura Setup
in UltiMaker 3D printers
Posted
Its a UMO+, I think i've found the problem.
On my board is missing the two jumper safety1 and savety2. They cut the
electricity to the heater etc.