[Original with extrusion upgrade kit or Original+?]

UMO+ was around 995 when I purchased it. The upgrade extrusion parts will run you 400. Seems like your saving some cash. If you love tinkering, adjusting then go after the UM0+, if not go with UM2. When I first purchased the UMO+ there were times when I asked myself "why didn't you just get the UM2 you cheapa***!" LOL

[Ultimaker Original Plus HELP]

Well thank you all for the help. I successfully completed the Atomic Pull then ventured over to remove the brass fitting above the Heater block. I did NOT heat up the heater block and broke off the part lol. I ordered a new hot end and I should be receiving it tomorrow though. (Metal Expands when heated - Retracts when cooled) LOL

Now when re assembling should I heat up the heater block and re tighten the brass fittings? I can only assume the instructions advise us to hand tighten, but when the block heats up it expands and thats the culprit.

[Gluing PLA Plastic]

@killjoy have you tried this on PLA?  Or something else?

gr5 this works great with PLA and ABS. Been using it for years now,

[Gluing PLA Plastic]

Plastic Weld is my favorite. Dries in less then 10 seconds and holds on strong. It creates a chemical reaction so your not left with any crease.

[Ultimaker Original Plus HELP]

Thank you for the response and links. I do not see these two issues on these articles hoping they are normal? (Burn marks and leakage)

[Ultimaker Original Plus HELP]

Good evening to all,

As any new member would; please accept my thank you in advance for any help what so ever. I am having problems with my prints. I realigned the z axis, and leveled the bed already so I know those two options are ok. Bed temp was set to 60c and nozzle temp was set to 205. I am using 2.85 PLA filament from ultimaker (white color).I am not sure of the cura version but I know its the latest 15 something.

Setting in CURA were set to HIGH QUALITY; I then switched over to advance settings carrying over the settings. I only updated the temp as I was thinking it was too high at 210. Please keep in mind I am a noob to 3D printing so this may be a good print? not sure... Ive seen some awesome prints here so I am hoping its something that I can correct/adjust.