[Blocked nozzle. Atomic method not working.]

After posting on the forum it came to mind that the blockage would be happening above the nozzle. So i let it cool and took the nozzle off; sure enough there was a small piece of filament that was stuck there and i pushed it up from the bottom.

Went on and performed the atomic method twice and now printing again.

Thanks for the help.

PS: no es mi idioma, solo vivo en Espana, y me da casi igual cual de las dos idiomas hablo, pero prefiero el ingles. Gracias.

[Blocked nozzle. Atomic method not working.]

Hello,

I was in the process of printing a ±30 hour print and it stopped 5 hours away from finishing.

I noticed the nozzle is blocked so i tried to apply the atomic method to clear it up but it was unsuccessful.

Every time I put the filament in trough the top it seems like it doesnt reach the nozzle and i cant proceed with atomic method. I tried using acupuncture needles and sewing needles from the bottom but that was unsuccessful as well.

I am a bit frustrated, since it is an important project for me, and I tried everything. At this point ordering a new nozzle would not help because it would take too long.

Any tips would be greatly appreciated.

PS: I should mention that I am using a hemp based biodegradable plastic filament, which we make ourselves. Printed lots of big and small prints with it, never had a problem like this; the atomic method always seemed to do the job.

Regards,

Alex.